INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Locate and remove plastic cover next to each tail light
revealing (1) screw and remove using an 8mm socket.
Locate on each side (1) plastic screw and remove using
screwdriver. Use plastic pry tool to remove the rest of
the plastic push pin. Set aside for later reinstallation.
4. Gently remove the bumper fascia starting at the outside
of the vehicle and working towards the rear of the
vehicle. Locate on the bumper fascia and unplug (2)
electrical plugs. Set aside for later reinstallation.
5. Locate along the panel and remove (5) screws using an
8mm socket. Next locate and remove (8) M14 bolts, (4)
on each side of the bumper beam using a 21mm socket.
Set both pieces aside for later reinstallation.
6. Raise hitch into position lining up the holes with the hole
in the bumper beam and loosely fastening the (8) M14
bolts removed from Step 5. Torque the M14 bolts to 126
ft-lbs. Reinstall following steps 1-5 in reverse order.
Summary of Contents for 13291
Page 4: ......
