INSTALLATION INSTRUCTIONS
CUSTOM WIRING HARNESS
WIRING LOCATION GUIDE
APPLICATIONS
NOTICE
WARNING
TOOLS NEEDED
Signal Circuits
- 3.0 amps per side
Tail / Running Circuits
- 7.5 amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
10mm socket
Ratchet
Exceeding the product rating can cause loss of warranty,
overheating and potential fire. Do not exceed product rating
or tow vehicle lamp load rating, whichever is lower.
Make
Model
Toyota
Hilux (Mexican vehicle)
Toyota
T-100
Toyota
Tacoma
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
PICKUP TRUCKS (T)
Representative vehicle shown below
T1
- Behind driver side taillight housing
T2
- Behind passenger side taillight housing
T3
- Behind driver side rear bumper
T5
- Behind passenger side rear bumper
T2
T5
T1
T3
All steps must be followed to ensure the wiring harness
will function properly. Once installed, test for proper function
by using a test light or connecting a properly wired trailer.
PAGE 1 • 55513-INS-RB
