Frequently Asked Questions
Q. What type of batteries can be used with the kit?
A. Factory set for AGM Batteries, but will charge Gel, Flood and Calcium Batteries too.
Q. Can I bypass the regulator to charge my battery?
A. ONLY when the kit is connected to the battery via another solar charge controller. A battery
should never be charged direct to any battery without a solar controller being used. Damage to
your battery or an explosion may occur as the voltage output by the solar panels will exceed the
battery charge limit. (VERY IMPORTANT TO NEVER CHARGE A BATTERY WITHOUT A
REGULATOR)
Q. Will the solar panels over charge my battery?
A. The solar controller (regulator) ensures that a steady charge is supplied and will not over
charge the battery. It has up to five levels of charging Soft Charge, Bulk Charge, Absorption
Charge, Equalization Charge (only for wet or calcium batteries) and Float Charge.
Q. Can I extend/lengthen the battery lead?
A. If the lead is extended this could result in a loss of voltage and insufficient power transferred
from the solar controller (regulator) to charge the battery. Quality wire should always be used to
extend the lead length.
Q. Is the Controller water resistant.
A. Yes it is waterproof but it is recommended during rain, hail or storms the kit be moved indoors
to protect it.
Q. How do I clean the solar panel?
A. Dust & dirt should firstly be swept off the panel surface using a soft brush and then use a wet
cloth to wipe the panel surface to remove remaining dirt & grime. It is recommended that any bird
droppings be removed as soon as possible as if left can cause damage to the surface.
Troubleshooting
Check all connections to ensure they are secure and free from moisture & debris.
Check the solar panels are in good sunlight.
Test the battery the solar kit is hooked to, to ensure it is not faulty.
Disconnect the solar kit from the battery wait 30 seconds and reconnect. This will restart the solar
controller.
To test if your kit is working, check the battery voltage before you connect the solar kit to it. Then
connect the solar kit and leave it on for 10 minutes, then check the voltage in your battery. The
battery voltage would now be higher than your first reading if the kit is working correctly.
If problems continue please consult your place of purchase.
Error code 601 means the kit is not connected to a battery.
Connect to a battery and this code will change and display the battery voltage.
