CAB INSTALLATION
18 of 28
STEP 23: (ACCESSORIES/PLUGS)
23.1
If installing accessories, please do so now. If not, use
the supplied plugs to fill any exposed holes. See
Figures 23.1a and 23.1b.
23.2
Per figure 23.2, install (7) insert covers.
23.3
Optional Rear Wiper Note:
For easier wiper motor harness disconnection, cut the
main wiring harness connector off a few inches from the
end and create a jumper harness with it using bullet
connectors.
Do not cut the connector off the wiper
motor
.
Strip all the wires, crimp a male bullet connector onto
the ground (black) wire of the main wire harness and a
female bullet connector on the positive (red) wire.
Reverse the male and female bullet connectors on the
new jumper wire harness so that the male bullet
connector is on the positive (red) wire and the female
bullet connector is on the ground (black) wire.
STEP 24: (FINISHING TOUCHES)
24.1
Install caution sticker on right side of ROPS per fig
-
ure 24.1.
24.2
Reinstall the grill guard and loader if equipped.
Tools required
19mm Wrench or Socket
24.3
Due to the nature of the packaging materials used for
shipping this product, the components of the cab
system may have dust on their surfaces upon removal
from the packaging. It is recommended that after
completion of the cab installation, the cab and vehicle
are washed thoroughly to eliminate any dust or
contaminants. See the Care and Maintenance section at
the back of this manual for critical information on
cleaning the cab.
Fig. 23.1a (Install Plugs, Door)
Rubber Plugs
Fig. 23.1b (Install Plugs, Roof)
Fig. 23.2 (Install Insert Covers)
Insert Covers
Plastic Plugs
Fig. 24.1 (Install ROPS Caution Sticker)
