Cleaning - Reassemble the Unit (cont.)
29 Prepare the tap handle assembly
for attachment. Lubricate each
tap seal with food grade lubricant.
Insert the seal into the tap hole on
the bottom of the bowl. Line up the
middle pins on the handle with the
mounting slots.
30 Attach the tap handle assembly.
Push in with your thumb on the
center of the handle until the handle
assembly pops into place.
31 Reassemble and reinstall each lid
and insert the light plug into the
socket behind each bowl.
Before starting up the unit again after
cleaning, rinse it out as follows:
32 Connect the power cord to the
electrical outlet.
33 Fill the mixing bowls with clean
water.
34 Turn the main power switch to the
ON (|) position. Push (|) on the
mixing switches for all of the mixing
bowls. Make sure the refrigeration
switches are OFF (O).
35
-FBWFUIFVOJUPOGPSmWFNJOVUFT
36 Drain the water from each of the
mixing bowls by placing a container
under the tap and pulling the lever.
Reinstall the Drip Trays and Wipe Up
37 Position the drain hose in the
opening in the top of each tray.
Then, insert the tabs on the back
of the drip tray into the holes on
the front of the chassis. Push down
gently to secure in place.
38 Wipe any dust or debris from the
exterior surfaces of the unit with
a damp cloth. Wipe up any spills/
liquids in the surrounding area.
CLEANING INSTRUCTIONS
CI31
FROZ BEV DISP, CLEANING INSTRUCTIONS
082418A
31
38
29
30
Spring must be
between mounts
Mount
Red seal
Push
here
Drain
hose
Front
panel
Line up as
shown
35
