Curtis CGC, Service Manual

2

1.    Brewer should be ON (confirm at the rear toggle switch). When a screen saver is running, touch the screen to restore the control screen. 

This screen should read Ready to Brew. 

2.  Place an empty cup under the brew cone.

5.  Slide the filled brew cone into the brew 

rails on the brewer.

3.   Place a clean filter into the brew cone.

4.  Fill brew cone with the proper amount of 

ground coffee.

COFFEE BREWING INSTRUCTIONS

WARNING TO AVOID SCALDING, Do not remove brew cone while brew light is flashing.

6.  Start the brew cycle by hold your finger 

on the  desired brew icon. As soon as 

you hear the click of the brew valve, the 

brew cycle has started and you can lift 

your finger.

Brew Code: 

You may find that when a brew 

button is pressed, a key pad appears on the 

screen. This is a brew lock-out feature that 

requires a code to be entered before a brew 

will start. The default is OFF. 

CAUTION: 

When enabled, as soon as you 

enter the brew code a brew cycle starts.
Refer to page 8 for more information about the 

Brew Code.

During the brew cycle, an animated coffee 

cup icon will appear on the screen and a 

brew timer will count down the time remain-

ing on the brew cycle.

Your Curtis Gold Cup Series is Factory Pre-Set for Optimum Performance.

After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for a moment. 

The screen will display 

             . Next 

is displayed. Water will fill the tank (2-3 minutes depending on water flow rate). 

When the proper level is reached 

          will appear on the screen. It takes approximately 30 minutes to reach the set point temperature.

Control will display   

   when temperature reaches the set point. The unit is now ready to brew.

MODEL NUMBER

CONTROL BD NUMBER

READY TO BREW

HEATING

FILLING