Dump Valve Calibration
After installing a new dump valve, do not reinstall the dump valve cover and canisters, so that you can perform the
calibration steps below:
1 Turn the toggle switch on the back of the unit to the ON position. Wait for the ready light to come on.
2 Place a measuring cup below the spout connected to the dump valve that was replaced.
3
1VTIUIF%*41&/4&CVUUPOGPSUIFTQPVUDPOOFDUFEUPUIFEVNQWBMWFUIBUXBTSFQMBDFE5JNFUIFnPXSBUF
8BUFSTIPVMEnPXBUBSBUFPGP[ P[.BYJOTFDPOET*GUIFnPXSBUFJT0,TLJQUPTUFQ*GUIFnPX
rate is too high or too low, perform the steps that follow.
4
0QFOUIFEPPSPOUIFGSPOUPGUIFVOJU6TJOHBNNIFYXSFODIUVSOUIFBEKVTUNFOUTDSFXPOUIFGSPOUPGUIF
WBMWFPOFIBMGUVSO5VSODPVOUFSDMPDLXJTFUPJODSFBTFUIFnPXSBUFPSDMPDLXJTFUPEFDSFBTF
5
$MPTFUIFEPPSBOESFDIFDLUIFnPXSBUF*GUIFnPXSBUFJTP[ P[.BYJOTFDPOETSFQMBDFUIFEVNQ
WBMWFDPWFSBOEDBOJTUFST*GUIFnPXSBUFJTTUJMMPVUPGDBMJCSBUJPOSFQFBUTUFQTBOEVOUJMUIFnPXSBUFJT
correct.
3FQMBDFUIFEVNQWBMWFDPWFSBOEDBOJTUFSTXIFOUIFnPXSBUFJTDPSSFDUUPSFUVSOUIFVOJUUPOPSNBMVTF
"MM1$(5TFSJFTVOJUTFYDFQU1SF4FU%JTQFOTFNPEFMTBSFFRVJQQFEXJUIBWBMWFDBMJCSBUJPOGFBUVSFUIBU
EJTQFOTFTXBUFSGPSTFDPOETFMJNJOBUJOHUIFOFFEGPSNBOVBMUJNJOH4FFUIF
Programming Guide
section.
TROUBLESHOOTING GUIDE
TG24
4%%6.17"-7&$"-5306#-&4)005*/((6*%&
ø
"