Installation of the Cup Locator (Optional Accessory
Available for PCGT3 and PCGT5 Series Models)
2 Remove the drip tray, if already installed.
3 Loosen (but do not remove) the screws that hold drip
tray clips in place.
INSTALLATION INSTRUCTIONS
II22
PCGT3 shown
Loosen
screws
Style may vary
Installation
Leveling
1 Position the dispenser on the counter top. Level it left
to right and front to back by turning the bottom of the
legs.
WARNING:
Use the leveling legs to level the
dispenser only. Do not use them to adjust
dispenser height. Do not extend them higher
than necessary.
1$(5&913*/45"--"5*0/*/4536$5*0/4ø
090919C
Back of unit
4 Slide the slots on the cup locator over the screws,
behind drip tray clips. Push down on the cup locator
until it stops.
5 Re-tighten the screws and attach the drip tray.
Connect the Water Supply
6 Flush the water supply line prior to installation to purge
BJSBOEEFCSJTGSPNUIFXBUFSmMUFSBOEUVCJOH
7
$POOFDUUIFXBUFSTVQQMZMJOFUPUIFnBSFmUUJOHPOUIF
back of the unit. Leave the water supply valve closed
until power is connected.