background image

 

-

12

programmed. 

3. 

Press PROGRAM (47) when you have reached the desired song. The track will be stored in 
PROGRAM. 

4. 

Repeat steps to program additional tracks. 

5. 

When programming is complete, press 

 

PLAY/PAUSE (9,28) to play the programmed 

track list. 

To review programmed tracks, presses PROGRAM (47) repeatedly. Press STOP to clear 
programmed tracks. 
 

Note on CD-R/RW discs 

 

Because of non-standardized format definition / production of CD-R/RW, playback quality & 
performance are not guaranteed. 

It is not responsible for the playability of CD-R/RW in any case due to recording conditions 
such as PC performance, writing software, media ability and etc. 

Do not attach  a seal or label to either side (the  record able side or the  labeled side) of  a 
CD-R/RW disc. It may cause malfunction. 

Do not load a un-recorded CD-R/RW disc. It will take over 30 seconds to read the disc. The disc 
may be damaged if you try to open the disc compartment while reading the disc. 
 

CARE AND MAINTENANCE 

 

Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact 
with the shiny, unprinted side of the disc. 

Do not attach adhesive tape, stickers etc., to the disc label. 

Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive 
cleaners to clean the disc. If necessary, use to CD cleaning kit. 

If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched). 

When cleaning the disc, wipe in straight lines from the center of the disc to the edge of the 
disc. Never wipe in circular motions. 

To remove a disc from its storage case, press down on the center of the case and lift the disc 
outs, holding it carefully by the edges. 

Fingerprints and dust should be carefully wiped off the disc’s recorded surface with a soft 
cloth. Unlike conventional records. Compact disc have no groove to collect dust and 
microscopic debris, so gently wiping with a piece of soft cloth should remove most particles. 

 
 
 
 
 

TROUBLESHOOTING GUIDE 

 
Should this unit exhibit a problem, check the following before seeking service. 
 

Symptom 

Possible Cause 

Solution 

Radio 

Station not tuned properly for 
AM or FM 

Retune the AM or FM broadcast 
station. 

Noise or sound distorted 
on AM or FM broadcasts. 

FM: Wire antenna is not 
extended. 

Extend FM Wire antenna. 

 

 

-

13

 

AM: The bar antenna is not 
positioned correctly. 

Reposition the unit until best 
reception is obtained. 

FM STEREO does not 
appear on display. 

You have tuned to a mono 
station or station too weak. 

Select another FM station. 

Unit not at Tuner function AM or 
FM band. 

Press Tuner Function button to 
AM or FM. 

AM or FM, no sound. 

Volume at minimum. 

Increase Volume. 

Compact Disc Player 

Unit not in CD function mode. 

Press CD Function button. 

CD Player will not play. 

CD is not installed or installed 
incorrectly. 

Insert CD with label side up. 

CD skips while playing. 

Disc is dirty or scratched. 

Wipe disc with cloth or use 
another disc. 

Function inoperative and 
jammed 

Built-in microcomputer hand up.  Use a sharp tip to press into the 

reset hole to reset the built-in 
microcomputer.   

Display no indication or 
abnormal indication 

Built-in microcomputer hand up.  Use a sharp tip to press into the 

reset hole to reset the built-in 
microcomputer.   

 

SPECIFICATIONS 

 
Power source  --------------------------------  AC110V-127V ~60 Hz   

DC 3V “AA” size/UM-3 x 2 pcs (not included)  for  remote 
Handset 

 
Power consumption -------------------------  28 Watts 
 
Dimension ------------------------------- Unit   340 (W) x 151 (D) x 320 (H) mm (including support plate) 
 

  340 (W) x 102 (D) x 320 (H) mm (without support plate)   

 

Speaker   200 (W) x 143 (D) x 320 (H) mm (including support plate) 

 

  200 (W) x 94 (D) x 320 (H) mm (without support plate) 

 
Tuning range/sensitivity --------------------  AM 530 ~ 1710KHz/2000 

µ

V/m 

 

  FM 87.5 – 108MHz/18uV   

Playback system ------------------------------ Vertical type CD mechanism   
Frequency response ------------------------- 100 – 18,000 Hz 
Power output ----------------------------------- 3.5 Watts @ Maximum per channel 
Speaker impedance -------------------------- 3.2 ohms 
Headphone impedance ---------------------  8 – 32 ohms 
AUX input sensitivity ------------------------- 300 mV 
 
ACCESSORIES 

Instruction Manual   

1 set 

Remote Control handset 

1 pc 

Support plate 

6 pc 

Sleeve For Support plate 

6 pc 

Wall mounting template 

1 pc 

Screw 

4 pcs 

Plastic anchor 

4 pcs

 

   

172-401Y10081-CU 

Summary of Contents for RCD641








Reviews: