STEP 1. BEFORE INSTALLATION – PREPARE THE COUNTER TOP
Holes must be cut into the counter top prior to installing the
brewer. The hole pattern is critical for proper operation of the
Seraphim coffee brewer. See Figure 2 below for the basic
counter layout. The two brew heads must fit within a 2 foot by
3 foot area.
Packed with the unit is a full-size template (Part № WC-
390245). Use the template for cutting the required holes
needed for installing the brew heads, touchscreen and drip
tray. The two largest circular holes are for the brew head
assemblies, along with three stud holes for the mounting
plate for each head. Also, there is a circular hole for the touch
screen, along with the two mounting holes. The drip tray can
be inset into the counter or mounted flush. Inset installation is
recommended. The rectangular hole shown below is for inset
installation. If the drip tray will be mounted flush, a circular
hole is drilled in the location shown for the drain instead of a
rectangular hole.
Consideration must be made for the drip tray drain system.
The drip tray comes with a 1/2” NPT X 3” nipple for
connecting the drain system (supplied by the purchaser) to
the drain fitting located on the bottom of the drip tray. See
Figure 3 on the facing page for dimensions.
2
WATER
HEATER
LEFT
BREW
HEAD
RIGHT
BREW
HEAD
UCM
TOUCH
SCREEN
COUNTERTOP
Figure 1 - Cabinet Installation Showing Four Main Sections
of Seraphim Brewing System
Figure 2 - Hole Pattern Template for Cutting and Drilling Counter Top (Drawing Not to Scale)
1 21/32”
[4.2 cm] 2X 3/4”
[1.9 cm]
2X 3/4”
[1.9 cm]
1 21/32”
[4.2 cm]
1 1/4”
[3.2 cm]
1 1/4”
[3.2 cm]
2 3/4”
[7.0 cm]
2 3/4”
[7.0 cm]
1 1/4”
[3.2 cm]
1 1/4”
[3.2 cm]
3 1/2”
[8.9 cm]
WATER HEATER
OUTLINE AREA
SPRAY HEAD
CUTOUT
SPRAY HEAD
CUTOUT
TOUCH SCREEN
CUTOUT
20 1/2” X 7 1/2”
RECTANGULAR CUTOUT
INSET DRIP TRAY
INSTALLATION ONLY
CURCULAR DRAIN
CUTOUT FOR FLUSH
DRIP TRAY
INSTALLATION ONLY
ALLOW ROOM FOR 3/4”
LIP AROUND OUTSIDE ON
INSET DRIP TRAY
INSTALLATION
Ø 2 1/4”
[5.7 cm]
Ø 2 1/4”
[5.7 cm]
6”
[15.2 cm]
6”
[15.2 cm]
3X Ø 5/16”
[8.0 mm]
2X Ø 5/16”
[8.0 mm]
Ø 1 1/2”
[3.8 cm]
1/4”
[6.4 mm]
Ø 1 3/8”
[3.5 cm]
3X Ø 5/16”
[8.0 mm]
1”
[2.5 cm]
CL
CL
6 7/8”
[17.5 cm]
8 1/2”
[21.6 cm]
7 1/2”
[19.1 cm]
10 1/4”
[26.0 cm]
10 1/4”
[26.0 cm]