FCC Requirements
NOTE
:
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
Changes or modifications not expressly approved in writing by may void
Some cordless telephones operate at frequencies that may cause interference to
nearby TVs and VCRs. To minimize or prevent such interference, the base of the
cordless phone should not be placed near or on top of a TV or VCR. If interference is
experienced, moving the cordless telephone farther away from the TV or VCR will often
1.
Reorient or relocate the receiving ANTENNA.
2.
Increase the distance between the equipment and the receiver.
3.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4.
Consult the dealer or an experienced radio/TV technician for help.
to radio communications.
the users authority to operate this equipment.
reduce or eliminate the interference.
If trouble is experienced with this equipment, for repair or warranty information, please
contact service center at the below. If the equipment is causing harm to the telephone
network, the telephone company may request that you disconnect the equipment until
the problem is resolved.
Service can be obtained at:
Curtis International Ltd.
c/o Vision Transportation
4600, Witmer Industrial Estate
Unit 12, Niagara Falls, N.Y. 14305, USA
Tel: 1-800-968-9853
AC ADAPTOR: Use only with class 2 Power Source, 9V DC output, 300mA,
center pin positive
correct the interference by one or more of the following measures:
