4.
Select the desired volume level using the Rotary Volume Control.
5.
To turn the radio off adjust the Radio On/OFF/Auto switch to “off”
RADIO SPEAKER ON/OFF BUTTON
During the radio was in using mode. when it had incoming call and you pick up the hand set. The
radio will temporary turn off. After you put down the hand set. The radio will being in using mode
again.
TO SET THE TIME
Step 1--- Press the Time set button together with the HOUR or MINUTE button to set the correct
time.
Note: Repeat the above steps if you run past the correct time.
A glowing dot appears in the lower left hand corner of the display, indicating that the time shown
is PM time.
TO SET THE ALARM
Step 1--- Press the Alarm set button to check the alarm time.
Step 2---Press the Alarm set button together with the HOUR or MINUTE button to adjust the
alarm time, paying close attention on the PM indicator.
NOTE: A glowing dot appears in the lower left hand corner of the display indicating that the alarm
has been set to operate
TO WAKE BY RADIO
Step 1--- Set the alarm as previously instructed.
Step 2 ---Turn the radio on and select the desired radio station and volume setting as previously
instructed.
Step 3 --- Slide the AUTO/OFF/ON switch to “AUTO” position.
Your unit is now set to turn on automatically at the pre-selected alarm time.
TO WAKE BY BUZZER
Step 1-- Follow step 1 to step 3 under “TO WAKE TO RADIO”.
Step 2--- Rotate the VOLUME/BUZZER switch to the “BUZZER” position.
You will be awakened at the pre-selected alarm time by the buzzer tone.
To turn the Buzzer off, slide the AUTO/OFF/ON switch to the “OFF”
position or press ALARM SET/OFF Button.
