Curtis TV2010, Operation Manual

1. 

Press MENU button repeatedly to display Search menu. 

2. 

Press CH- or CH+ to select Channel menu item. 

3. 

Press V- or V+ to select the unwanted channel. 

4. 

Press CH- or CH+ to select Skip. 

5. 

Press V- or V+ to select Skip ON. 

Thus, after exiting the menu, the channel will then be skipped when you select programs with the 
Channel up/down button. If you want to skip other unwanted channels, repeat steps above to 
change the channel number. 

Notes: 

You can select the skipped channel by pressing the direct channel select buttons. 

To restore a skipped channel 

Use direct channel select buttons (0-9) to select the channel you want to restore. Enter into Search 
menu, press CH- or CH+ to select Skip, press V- or V+ to select Skip Off.   

Fine Tuning 

Fine tuning is not necessary under normal conditions. However, in area of inferior broadcast 
conditions where adjustment is necessary for a better picture and sound, use Fine tuning.   

1. 

Select the channel you want to fine-tune.   

2. 

Enter into Search menu, press CH- or CH+ to select Fine Tune,   

3. 

Press and hold V- or V+, the channel begins fine tuning until the best possible picture and 
sound is achieved. (Press V- to fine-tune downward, while V+ to fine-tune upward. The 
AFT function will be set to OFF mode automatically) 

4. 

To exit the menu, press DSP button or repeatedly press MENU button. 

Auto Fine Tuning (AFT)   

If picture and sound's effect of the channel is instead poor by making use of Fine Tune, you can 
correct them by making use of AFT. Enter into Search menu, press CH- to select AFT then press 
V-or V+ to select AFT On.   

CHANNEL SELECTION 

You can select your desired TV program by one of the following methods.   
Use Direct Channel Select buttons   

►

 AIR Mode Direct Channel Selection 

When the Signal Input menu option in Search menu is in the Air position, all channels can be 
selected by directly entering the channel number.   

►

 CATV Mode Direct Channel Selection 

When the Signal Input menu option in Search menu is in the CATV position, channels can be 
selected as follows:   

Method 1: 

Directly enter the channel number and wait for some time.   

Method 2:   

1-9:   

Press “0” twice, then 1-9 as needed. For example, to select channel 2, press “002”.   

10-99:    Press “0”, then the remaining 2 digits. For example, to select channel 12, press “012”.   
100-125:  Press the 3 digits in order. For example, to select channel 120, press “120”.   

Use Channel up/down buttons   

Press CH+ button, the channel number increases; Press CH-button, the channel number decreases.   
 
Use previous channel button   

Press 

  button to switch between the current channel and the previous one.