Curtis TV2740, Operation Manual

 menu. 

Thus, afte

 then be skipped when you select programs with the 

1. 

Press MENU button repeatedly to display Search

2. 

Press CH- or CH+ to select Channel menu item. 

3. 

Press V- or V+ to select the unwanted channel. 

4. 

Press CH- or CH+ to select Skip. 

5. 

Press V- or V+ to select Skip ON. 
r exiting the menu, the channel will

Channel up/down button. If you want to skip other unwanted channels, repeat steps above to 
change the channel number. 

Notes:

ou can sel

¾

Y

ect the skipped channel by pressing the direct channel select buttons. 

elect the channel you want to restore. Enter into Search 

ecessary under normal conditions. However, in area of inferior broadcast 

to select Fine Tune,   

st possible picture and 

4.

ss MENU button. 

hannel is instead poor by making use of Fine Tune, you can 

To restore a skipped channel 

Use direct channel select buttons (0-9) to s
menu, press CH- or CH+ to select Skip, press V- or V+ to select Skip Off.   

Fine Tuning 

Fine tuning is not n
conditions where adjustment is necessary for a better picture and sound, use Fine tuning.   

1. 

Select the channel you want to fine-tune.   

2. 

Enter into Search menu, press CH- or CH+ 

3. 

Press and hold V- or V+, the channel begins fine tuning until the be
sound is achieved. (Press V- to fine-tune downward, while V+ to fine-tune upward. The 
AFT function will be set to OFF mode automatically) 
To exit the menu, press DSP button or repeatedly pre

Au

F

If picture and sound's effect of the c

to  ine Tuning (AFT)   

correct them by making use of AFT. Enter into Search menu, press CH- to select AFT then press
V-or V+ to select AFT On.   

CHANNEL SELECTION 

rogram by one of the following methods.   

n

earch menu is in the Air position, all channels can be 

rch menu is in the CATV position, channels can be 

 the channel number and wait for some time.   

s “0” twice, then 1-9 as needed. For example, to select channel 2, press “002”.   

ess CH-button, the channel number decreases.   

se previous channel button   

You can select your desired TV p
Use Direct Channel Select buttons   

Ź

 AIR Mode Direct Channel Selectio

When the Signal Input menu option in S
selected by directly entering the channel number.   

Ź

 CATV Mode Direct Channel Selection 

When the Signal Input menu option in Sea
selected as follows:   

Method 1: 

Directly enter

Method 2:   

1-9:  

Pres

10-99:

Press “0”, then the remaining 2 digits. For example, to select channel 12, press “012”.

100-125: Press the 3 digits in order. For example, to select channel 120, press “120”.   

Use Channel up/down buttons   

Press CH+ button, the channel number increases; Pr

U

Press 

  button to switch between the current channel and the previous one.