ELECTRIC THREE WHEEL SERVICE VEHICLE
Page 7
Owner’s Manual and Service Guide
Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS,WARNINGS and DANGERS.
TOWING
This vehicle is not designed to be towed.
It is recommended that this vehicle be moved by placing
the entire vehicle on a trailer, flatbed truck or other suit-
able transport.
LIFTING THE VEHICLE
Tool List
Qty. Required
Floor jack .................................................................... 1
Jack stands ................................................................. 2
Chocks ........................................................................ 4
Chain hoist .................................................................. 1
Some servicing operations may require the vehicle be
raised.
To prevent possible injury or death result-
ing from a vehicle falling from a jack, be
sure the vehicle is on a firm and level sur-
face. Never get under a vehicle while it is
supported by a jack. Use jack stands and
test the stability of the vehicle on the
stands. Always place chocks in front and
behind the wheels not being raised. Use
extreme care since the vehicle is extremely
unstable during the lifting process.
Never attempt to raise the rear wheels of a
three wheel vehicle without first raising the
front of the vehicle and supporting on jack
stands.
When lifting vehicle, position jacks and jack stands
only on the areas indicated.
Due to the low ground clearance and short wheel base,
the vehicle should only be raised enough to remove the
front axle or the rear wheels. Servicing that requires
access to the underside of the vehicle should be accom-
plished by raising the front of the vehicle with a chain
hoist attached to the front frame members. Always use
an additional safety chain to prevent injury should the
To remove a wheel or the front axle, loosen the hardware
and turn the front wheel to the position indicated (Ref Fig.
7). Position a jack in the location indicated and carefully
raise the front of the vehicle. Position the jack stands as
shown. Use care not to place the jack or stands where
they could interfere with wiring or linkages. Slowly lower
the jack and test the stability of the vehicle.
To raise the rear of the vehicle, first raise the front of the
vehicle as previously described and support on jack
stands. Then position the jack in the position shown at
the rear of the vehicle. Carefully raise the rear of the
vehicle with the jack and place two jack stands in the
position shown. Slowly lower the jack and check that the
vehicle is securely supported by the jack stands before
proceeding.
Lower the vehicle by reversing the lifting sequence.
ROUTINE MAINTENANCE
This vehicle will give years of satisfactory service, provid-
ing it receives regular maintenance. Refer to the Periodic
Service Schedule for appropriate service intervals (Ref
Fig. 7 Lifting the Vehicle
View from underside of vehicle
1
3
2
4
4
2
(See detail)
Turn wheel as shown
to permit jack placement
Place jack along
the flat edge of
footrest
Detail
