MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5 - 20
5
trols clean. Keep area around muffler free of any combustible material.
At least once a year, (or more often under adverse conditions) the cooling system should be cleaned. Cleaning will
assure an adequate supply of air to the cooling fins. Compressed air may be used for routine cooling system mainte-
nance.
REAR AXLE
The rear axle is provided with a lubricant level check plug located on the driver side at the rear of the housing.
Unless leakage of rear axle lubricant is evident, an annual lubricant check is sufficient.
Checking The Lubricant Level
Tool List
Qty.
Socket, 13 mm, 3/8" drive....................................................................................................................................... 1
Ratchet, 3/8" drive .................................................................................................................................................. 1
Funnel..................................................................................................................................................................... 1
Clean the area around the check and fill plugs. Remove the check plug. The correct lubricant level is
just
below the
bottom of the threaded hole. If lubricant is to be added, remove the fill plug and add lubricant using a funnel. Add
lubricant slowly until lubricant starts to seep from the check plug hole. Install the check plug and the fill plug. In the
event that the lubricant is to be replaced, a drain plug is provided at the bottom of the differential housing.
Summary of Contents for 622010
Page 1: ...622010 Owner s Guide ISSUED JULY 2011...
Page 75: ......
