Page E-9
Repair and Service Manual
B
B
FRONT SUSPENSION AND STEERING
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
of the rollers requires replacement of the bearing. If the
roller portion of the bearing is to be replaced, the race
must also be replaced.
To install race (5), make sure bore of hub (1) is clean
and place new race over bore of hub. Evenly tap with
hammer and bearing driver to drive race fully in bore.
Repeat on other side of hub.
Clean spindle (2) and pack new bearings with grease.
“Wheel Bearing Packing” on page E - 2.
Fig. 11 Wheel Bearing Replacement
Install inner wheel bearing (4) and new grease seal in
hub and mount hub to spindle. “Hub Replacement” on
page E - 8 Adjust bearing. “Wheel Bearing Adjustment”
on page E - 3.
Replace the dust cap (7).
Lower vehicle per SAFETY section and tighten front
wheel(s) per WHEELS AND TIRES section.
Front of Vehicle
1
4
7
2
3
6
5
