MAINTENANCE 5
en-31
5.26 ELECTRICAL SYSTEM _____________________________________________________
General precautions that can be taken to reduce
electrical problems are listed below:
1.
Ensure all terminals and connections are clean and
properly secured.
2.
Check the Interlock System and fuses regularly.
If the Interlock System does not function properly and
the problem cannot be corrected contact an
authorized Jacobson Dealer.
3.
Keep the wire harness and all individual wires away
from moving parts to prevent damage.
4.
Check the battery and battery charging circuit.
5.
Do not wash or pressure spray around electrical
connections and components.
6.
Circuits are protected by fuses located under the
front cowl and a fuse located near the cooling fan.
Figure 5S
5.27 DASH PANEL _____________________________________________________________
The dash panel contains gauges and instrument lights to
display unit functions. Maintenance of the panel is limited
to replacing bulbs and setting the DIP switches.
Remove the four screws securing the instrument panel to
the dash.
Pull panel out, tilt panel forward and disconnect electrical
connector for easier access to rear of panel.
Light Bulb Replacement:
1.
Determine which bulb needs to be replaced.
2.
Rotate bulb holder 1/4 turn counter-clockwise and
pull up and away from dash panel.
3.
Replace old bulb with a new bulb of equal type.
Location ........................... Replacement Bulb
A Voltmeter.............................C658
B Temperature Gauge............C658
C Fuel Gage ...........................C658
D Hour Meter..........................C658
E Tachometer .........................C161
F Left Turn Signal...................C161
G Oil Pressure ........................C161
H Glow Plug ...........................C161
J Brake Fluid..........................C161
K Right Turn........................... C161
L Parking Brake ..................... C161
M High Beam.......................... C658
N Alternator / Battery ............. C161
4.
Place bulb and holder back into panel. Turn holder
1/4 turn clockwise to secure into panel. Ensure base
of holder is properly seated in panel.
CAUTION
Always turn the ignition switch to the OFF position and
remove the Negative (BLACK) battery cable before
inspecting or working on the electrical system.
!
Dash Panel,
Fuel Pump
& Ignition
Accessary
Heater
Accessary
Wiper,
Dome Light &
Back-Up Alarm
Power Port
Brake Light,
5th Wheel Brake
Flashers &
Horn
Headlights
15 A
10 A
10 A
15 A
20 A
10 A
10 A
10 A
Radiator
Fan
Diesel Engine
Gas Engine
ECU, Main Relay,
Injectors
Heater
Accessary
Wiper,
Dome Light &
Back-Up Alarm
Power Port
Brake Light,
5th Wheel Brake
Flashers &
Horn
Headlights
15 A
10 A
10 A
15 A
25 A
Dash Panel,
ECU, Fuel
& Engine Coils
20 A
15 A
Backup Alarm
Shift Switch
10 A
ECU
10 A
10 A
Accessary 10 A
10 A
Summary of Contents for 84063 - Kubota D1105-E3B Diesel Engine
