B
26
OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Guide
TCT Operation
With the switch in TOW position:
•
the controller is deactivated
•
the electronic braking system is deactivated which allows the
vehicle move freely
•
the warning beeper is deactivated
With the switch in RUN position:
•
the controller is activated
•
the electronic braking system and warning beeper features are
activated
A TCT vehicle operates in the RUN position only.
With the switch in RUN position and all of the following occurrences:
•
the vehicle is stopped for more than one second
•
the accelerator pedal is released for more than one second
•
the vehicle starts to roll more than 2 mph (3 kph)
the pedal-up brake system limits the speed to approximately 2 mph (3
kph) and the warning beeper activates. When the accelerator pedal is
pressed, the pedal-up brake and warning beeper stops and normal oper-
ation continues. The system functions in all key switch positions.
The TCT system is not a alternative for the brake. Use the brake pedal to control speed and
decrease the risk of injury.
With the switch in RUN position and all of the following occurrences:
•
the vehicle being driven down a slope
•
the vehicle speed is more than the specified top speed with the accelerator pedal pressed
or
released
the pedal-up brake limits the speed of the vehicle to the specified top speed. When the regenerative braking feature is
activated by this sequence of occurrences, the motor generates power which is returned to the batteries.
Test the TCT system each month. Allow the vehicle to move downhill with the accelerator pedal released. The braking
force must be felt at approximately 2 mph (3 kph) indicating that the TCT system is in operation. If the speed continues to
increase, apply the brake to control speed and continue with diagnostic check.
When you charge the vehicle, the diagnostic mode is deactivated and the handheld diagnostic tool does not operate.
The run/tow switch is found below the passenger side of the seat on the ESC environmental cover.
Controller
Environmental
Cover
RUN
TOW
MAINTENANCE
STORAGE
TOWING - Always select
‘TOW MAINTENANCE STORAGE’
position before towing
WAIT 30 seconds after reconnecting batteries BEFORE
turning key switch to ‘REVERSE’, ‘FORWARD’ or
‘NEUTRAL’ positions.
ALWAYS turn key to ‘OFF’ before
disconnecting or reconnecting battery wires.
ELECTRICAL ARC or BATTERY EXPLOSION
can occur if key is not in the ‘OFF’ position.
To disable electrical system, turn key switch to ‘OFF’ and
remove battery wires.
DO NOT alter or tamper with this unit. Unauthorized
modifications can result in SERIOUS INJURY or damage
to the vehicle and will void the warranty.
613048
Summary of Contents for Hauler 800XE
Page 1: ...OWNER S GUIDE 642988 B HAULER 800XE REVISED FEBRUARY 2016 ISSUED FEBRUARY 2015...
Page 61: ......
Page 62: ......
