MHW 0002 – DK 1693 | Version 001 – 14/09/2017 | custo med GmbH
2
[2] Resting and Stress ECG hardware, custo cardio 200 |
page 9
Resting and Stress ECG
Hardware, description of device for custo cardio 200
Push custo cardio 200 into the bracket on the
boom from the top. To do this, pull the safety bar
back and push the device into the bracket
until it clicks into place so that the safety bar
is moved back to the front.
custo cardio 200 supply line for the
connection to the power supply unit *)
SAFETY INSTRUCTIONS FOR USING
THE TELESCOPE BOOM
To securely move the device trolley with the telescope boom:
· fix the telescope boom (tighten the locking device )
· set the angle of the boom arm to 90 degrees
(height adjustment :
push the lever
and simultaneously move
the boom arm to the required position by moving
the end of the boom arm up or down,
do NOT pull the device
)
· pull the boom arm in completely (extraction lock )
ASSEMBLY custo cardio 200 USB
Attach the USB cable to the device, pull the arm of the boom out
until it reaches the maximum length. Route the USB cable along
the boom and fix it using the Velcro fasteners.
Important: Only connect the USB cable after the installation
of the software to the PC.
*) Note on the power supply: Use only the supplied power supply unit (part no. 85055).
