Custo Med custo cardio 400 accu, Operating Manual

MHW 0012 – DK 1713  |  Version 004 – 20/04/2020  |  custo med GmbH

2

Resting and Stress ECG

Hardware, description of device for custo cardio 400 BT and custo cardio 400 accu

[2] Resting and Stress ECG Hardware, custo cardio 400 devices | 

page 11

Fasten custo move extension arm in the fixture

Viewed from above, turn custo move clockwise until 

the stop of the fixture. Then fasten the inset in the 

fixture with the supplied screw (on the left side of the 

fixture when viewed from the front). The extension 

arm is now completely mounted. 

Inserting custo cardio 400 accu 

into the custo move extension arm

 Insert custo cardio 400 accu from above into the 

bracket on the extension arm. To do this, pull the safe-

ty bar to the rear and press the device into the bracket 

until it engages, so that the safety bar folds forward 

again.

IMPORTANT: 

Only connect the USB cable to the PC 

after the software installation.

Using the swivel range

Open the quick-release fastener of the anti-rotation 

lock to the left and turn custo move to the desired 

position.

To move custo move safely from one place to anoth-

er, align the extension arm straight forward. The an-

ti-rotation lock is located centrally on the back of the 

bracket. Close the quick-release fastener of the an-

ti-rotation lock (press the handle to the right).

Disassembly, 

remove custo move from the fixture

Remove custo cardio 400 accu from the custo move 

bracket. To do this, disconnect the USB cable and ex-

ternal power supply if necessary, pull the safety bar 

backwards and remove the device from the top. Loosen 

the screw that fixes the custo move extension arm (on 

the left side of the fixture, seen from the front).

Position the removal tool on the stop in the right-hand 

side of the transverse groove of the inset (viewed from 

behind). Open the anti-rotation lock (fold the quick-re-

lease fastener to the left). Turn custo move extension 

arm to the stop against the tool (anti-clockwise). 

The groove of the inset is again flush with the groove 

of the fixture. Align the anti-rotation lock again so 

that it is in the vertical groove. The custo move exten-

sion arm can be pulled upwards.

pull the safety bar 
to the rear