MHW 0012 – DK 1713 | Version 004 – 20/04/2020 | custo med GmbH
2
Resting and Stress ECG
Hardware, description of device for custo cardio 400 BT and custo cardio 400 accu
[2] Resting and Stress ECG Hardware, custo cardio 400 devices |
page 15
2.5.3
custo cardio 400 device states in standard operation
Energy saving mode
:
The On/Off button flashes blue and the suction level
and status display show the charging status (middle LEDs flash green, blue or
purple, see chapter
2.5.2 custo cardio 400 display and control elements
).
Briefly pressing the On/Off button puts the custo cardio 400 accu into standby,
see
next paragraph
. The device can also be activated directly via custo diagnostic by
calling up the ECG interface. custo cardio 400 accu is put back into energy saving
mode after one minute of inactivity.
Standby
/
:
The On/Off button lights up
constantly blue. The device functions are active. The suction level control can be
activated by briefly pressing the On/Off button , e.g. to put the electrode leads
on the patient. Otherwise, the suction level control is automatically activated when
the ECG interface is called up,
see next paragraph
. The cleaning can be started by
pressing the cleaning button (longer blowing out of the electrode leads, e.g. for
30 minutes).
Monitoring, status before an ECG recording
/
:
When the ECG interface is called
up in custo diagnostic, the suction level control is activated and the electrode leads
can be applied to the patient. The patient‘s ECG signal is displayed on the screen. In
this state, the On/Off button as well as the suction level control light up blue
and the suction level and status display shows the preset suction level in the co-
lour of the operating mode. The suction level can be adjusted manually by pressing
the buttons (in this case the automatic suction level control is deactivated,
see
chapter 2.5.4
).
ECG recording
/
:
The recording is triggered in custo
diagnostic with the Start or Autostart button. Manual start by pressing the button
on the device is also possible,
see chapter 2.5.4
. The indicator lights during a recor-
ding corresponds to the display during the monitoring.
:
If the charging level is below 20 %, the suction level and
status display lights up purple during operation at the set suction level instead of
the colour of the current operating mode. Charge the device promptly!
State when the ECG recording ended
/
:
When the ECG recording is ended,
the electrodes are discarded and the electrode leads are briefly blown out. The On/
Off button and the cleaning button light up blue, the suction level and status
display lights up green for the duration of the blow-out. The green suction level
and status display will decrease in accordance with the detachment time that
has already elapsed (if the total duration of the detachment time is less than one
minute).
and
