You can subscribe up to 5 handsets to one base unit.
!!! You only need to subscribe the handset if:
The handset subscription has been removed or lost from the base unit or if you want to
subscribe a replacement or additional handset to this base.
Please see the section on “Multiple Handsets or Bases” for the Register / Pair Procedure.
9. Base Settings
9.1 Setting the Recall / Flash Time (Default is LONG)
(only change this for some non standard business exchanges)
Recall time should normally be set to “LONG” for New Zealand.
Press Menu/OK Key
Use the Up or Down Keys to scroll to ‘
BASE
’ and press OK.
Use the Up or Down Keys to scroll to ‘
RECALL
’ and press OK.
Use the Up or Down Keys to select ’
LONG
’ or ‘
SHORT
’ and press OK.
Press ESC to move back up the menu or the Red OFF Key to close the menu.
9.2 Changing the PIN code (system PIN code Default is 0000)
Certain functions are only available if you know the PIN code of the base.
The PIN code must be 4 digits. If you would like to change the PIN code and set your own
secret code, do the following:
Press Menu/OK Key
Use the Up or Down Keys to scroll to ‘
BASE
’ and press OK.
Use the Up or Down Keys to scroll to ‘
SYSTEM PIN
’ and press OK.
Enter the old pin and press OK
Enter the new pin and press OK
Press the new pin again and press OK. If it is successful, it will display “ PIN CHANGED”
Note: If the wrong PIN code is entered, ‘
Error PIN
’ is shown.
Press ESC to move back up the menu or the Red OFF Key to close the menu.
10 Multiple Handsets or Bases - SETUP
Two (or more) individual sets of this model can be purchased and then combined to
create a multi handset system (or even a multi base system). With Multiple handsets
“correctly connected” ( Referred to as Subscribed / Registered or Paired) you can transfer
calls, use your phones as an intercom or make conference calls.
Normally the “new” base that comes with the “new” handset would not be used or only
used as a charger and not connected to a telephone line.
All handsets must share and connect to the phone line through the “original” base to be
able to communicate with each other (internal calls) and transfer external calls
By default, each set is supplied “Subscribed”( programmed) and ready to use as
“Handset 1 and Base 1”.
You can subscribe up to 5 handsets to one base unit and a handset can subscribe to
up to four different bases either on the same telephone line or on different lines.
12
