15
12 Technical Information
Type; Dect Digital
Frequency; 1880 - 1900 MHz
Range: Up to 300 m in open space up to 50 m in buildings
Dialling: DTMF (tone)
Batteries: 2 x 1.2V, 500 mAh AAA Type NiMH rechargeable
Max. standby time: approx. 100 hours
Max. talk time: 10 hours
Ambient temperature: +5 °C to +45 °C
Permitted relative air humidity: 25 to 85 %
Power supply base adapter: 230V, 50Hz
Memories:
50 entries (16 characters & 24 digits each)
13 Default Settings (also see section 8.1 default reset)
Handset volume 3 Handset Melody External Calls 8 Handset Melody Internal Calls 1
Flash time Long Dial mode Tone Ringer On/Off On Ringer Volume 5 Auto Talk Off
Base Select AUTO PIN Code 0000
• The other handset will start to ring.
• If the other handset answers the call by pressing their GREEN ON Button you can talk
internally.
• Either handset can press their RED OFF Button to end the call at any time.
11.2 External Call Transfer
During any external call, the active handset can BRIEFLY press their
INTERNAL K
ey
followed (within three seconds) by the number (1-5) of another registered handset. The
external call is put on hold and the internally called handset will start to ring:
– When the internally called handset presses their Green ON key you can talk internally.
– At this stage the initiating handset can switch between the internal and external calls
by BRIEFLY pressing their INTERNAL key.
If, while the internal call is connected and the external call is on hold, the initiating
handset presses their Off key, the external call will be transferred to the other handset.
Alternatively, at that time, if the internally called handset presses their Off key first, then
the initiating handset will be reconnected exclusively to the external call.
Whichever handset is finally connected to the outside call must press their RED OFF
button to end the outside call.
11.3 Conference Call during an External Call
(As Above) During any external call, the active handset can BRIEFLY press their
INTERNAL
key followed (within three seconds) by the number (1-5) of another registered handset.
The external call is put on hold and the internally called handset will start to ring:
– When the internally called handset presses their ON key you can talk internally.
– At this stage the initiating handset can switch between the internal and external calls
by BRIEFLY pressing their INTERNAL key. If the initiating handset then presses and HOLDS
the
INTERNAL
key for 2 seconds you can talk with the 2nd handset and the external line
at the same time (Conference Call)
Either Handset can press Off key and be disconnected while the other handset
continues the conversation. (both handsets at some stage must Press their RED OFF
button to completely end the call)
