CAUTION.
Use only RECHARGEABLE TYPE AAA 1.2volt NiMH
BATTERIES.
Use of REGULAR type will cause overheating and
irreparable damage to the unit.
1 Initial Setup - Connections
Connect the telephone line cord and the power
adaptor to the rear of the base unit
Connect the telephone line to your wall jack.
NOTE - If you have high speed internet in the
building that requires telephone filters on each
outlet, add a suitable telephone filter before
connecting to the wall jack.
Connect the power adaptor to a reliable outlet.
NOTE - loose power connections especially multi
outlet boxes can cause crackling sounds and
To Open gently press inwards HERE
Power Adaptor
Socket
Telephone Line
Socket
Install the batteries NOTE CORRECT POLARITY
+
_
+
_
3
Internal Calls Ringer Melody
11
Multiple Handsets or Bases Operation
Internal Calling / Intercom
External Call Transfer
Conference Calls
12
Technical Information
13
Default Settings
14
Troubleshooting
14
14
14
15
15
15
15
16
intermittent operation.
2 Batteries and Battery Charging
Remove the battery cover and insert the batteries supplied as shown below..
Before first use charge the batteries fully for 12 hours. Place the handset in the base and
observe the charging Icon on the screen. It should now be scrolling up and down.
With the handset off the charger the ikon shows the
level of charge remaining but it can give a false
surface charge reading whenever the phone has
only been on the charger for a short time. For best
battery life, less frequent overnight full charging
cycles are preferable to many short charging cycles.
After prolonged use the batteries will need replacing.
If you find the batteries run down quicker than
normal on standby or run flat quickly when talking, it
is time to replace them.
Slide the cover down and lift it off
Charge Icon
-Indicates battery level
-Pulses while charging
