CUSTOM/POS EMULATION
To deine the alignment point you need to set the device parameters that compose the numerical value of the “Notch Dis
-
tance” parameter. (see par.5.4).
For example, to set a notch distance of 15mm between the notch and the alignment point, the parameters must be set on
the following values:
Notch Distance Sign
: +
Notch Distance [mm x 10]
: 1
Notch Distance [mm x 1]
: 5
Notch Distance [mm x .1]
: 0
The “Notch Distance” parameter, may be modiied as follows:
•
during the Setup procedure of the device (see chapter 5)
•
by using the 0x1D 0xE7 command (for more details, refer to the Commands Manual)
•
by driver
74
Summary of Contents for Kube II
