5.2
Coniguration by software
The setup parameters can be set by using the “PrinterSet” software tool available on
For a detailed description of the device operating parameters see the following paragraphs.
To conigure the device by software, proceed as follows.
Start “PrinterSet” software tool.
Click on LOAD > FROM DEVICE and select
the device connected to the PC.
From Device
From File
SAVE
PORT
LOAD
Click on LOAD > From file and select a .psc file on your PC
Drag and drop a .psc file
Connect the device to a PC directly (see paragraph 4.5),
without using HUB devices.
2
3
1
Connect the device to a PC directly (see
),
without using HUB devices.
33
Summary of Contents for P3
