6
ACT
TM
CONTROLLER QUICK START
While the ACT
TM
crimper has the ability to perform a number
of fully automatic functions, manual operation is also possible.
To make a manual crimp, two numbers are needed:
•
The closed diameter of the die
(in either in or mm)
•
The fi nished crimp diameter
(in either in or mm)
That’s all you need to know. ACT
TM
does the rest.
TO MAKE A MANUAL CRIMP:
• Press
START MOTOR.
• Select
CRIMP TO DIAMETER.
•
Enter the closed diameter of the die set in either in or mm and press
ENTER
.
Note: for a 25mm die, enter 2500. ACT
TM
will add 2 decimal places
.
For a 1.5 inch die, enter 1500, ACT
TM
will add 3 decimal places.
• Enter
the
fi nished crimp diameter and press
ENTER
.
• From
the
ENTER CRIMP
screen, press the
MANUAL
button to put the crimper in manual mode.
• Confi rm that the die and fi nished crimp diameters are correct and that
MANUAL MODE
is displayed.
•
Press and hold the green close button until the crimper stops closing.
• Check
the
fi nal crimp diameter. If a minor correction is required see
HOW TO MAKE MINOR
CORRECTIONS.
Tip: Pressing the CHANGE DIES button allows the crimper head to be fully opened or closed with
the green OPEN-CLOSE buttons on the controller front panel When the CHANGE DIES button is
blinking the dies can be opened and closed manually without altering any of the crimper settings
.
Summary of Contents for CC1200
