CC650
Production / Industrial Hose Crimper
18
CC650 MIC MANUAL DIAL MICROMETER
The CC650 MIC is available with a manual dial micrometer in place of
the ACT
TM
controller. Set up and adapter and die installation are identical
to the CC650 ACT model.
The micrometer is a direct reading metric micrometer.
With the micrometer set at zero, the die set will close to the fully closed
diameter stamped on the face of the die.
The number set on the micrometer will be the amount
ABOVE
the closed
diameter of the die at which the dies will stop closing.
Example:
If the required fi nal crimp diameter for the hose and fi tting being
crimped is 65.5 mm, the correct die set to use would be a 63 mm
die set. The micrometer would be set at 2.5 mm as shown, and the
fi nal crimp diameter would be 65.5 mm (63 mm-closed die diameter
plus 2.5 mm)
Opening and closing of the crimper head is controlled with the foot
switch. Press and hold the foot switch until the crimp is complete and
the dies stop closing.
Always check the hose and fi tting with a caliper to be certain that the fi nal
crimp diameter is in accordance with the hose and fi tting manufacturers
specifi cations.
