7
GENERAL SAFETY (cont.)
KEEP protective guards in place and in working order.
CAUTION!
MAINTAIN your balance. DO NOT extend yourself over the tool. Wear oil resistant
rubber soled shoes. Keep floor clear of debris, grease, and wax.
MAINTAIN all machines with care. ALWAYS KEEP machine clean and in good working order.
KEEP all blades and tool bits sharp.
NEVER leave a machine running, unattended. Turn the power switch to the OFF position. DO
NOT leave the machine until it has come to a complete stop.
REMOVE ALL MAINTENANCE TOOLS from the immediate area prior to turning the machine ON.
WARNING!
STAY ALERT, watch what you are doing, and use common sense when operating
any machine. DO NOT operate any machine tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating power tools may result in
serious personal injury.
WARNING!
USE ONLY recommended accessories. Use of incorrect or improper accessories
could cause serious injury to the operator and cause damage to the machine. If in doubt, DO NOT
use it.
THE USE of extension cords is not recommended for 230V equipment. It is better to arrange the
placement of your equipment and the installed wiring to eliminate the need for an extension cord.
If an extension cord is necessary, refer to the chart in the Grounding Instructions section to
determine the minimum gauge for the extension cord. The extension cord must also contain a
ground wire and plug pin.
CAUTION!
Wear proper clothing, DO NOT wear loose clothing, gloves, neckties, or jewelry.
These items can get caught in the machine during operations and pull the operator into the
moving parts. Users must wear a protective cover on their hair, if the hair is long, to prevent it from
contacting any moving parts.
SAVE these instructions and refer to them frequently and use them to instruct other users.
NOTE:
Information regarding the safe and proper operation of this tool is also available from the
Summary of Contents for 40200H-CT
Page 25: ...25 PARTS 97...
Page 26: ...26...
