4
the tool. This reduces the risk of serious injury should objects fall.
• Only use Hole Cutting Tools to cut holes in pipe as instructed in this manual. Do not use for
other purposes or modify. Other uses or modifying this tool for other purposes may increase
the risk of serious injury.
• Read and understand the instructions and warnings for all equipment being used before
operating the Hole Cutting Tool. Failure to follow all instructions and warnings may result in
property damage or serious personal injury.
Description, Specifications
Description
The JK114 pipe hole cutter is designed to cut holes up to 114mm into steel pipe. The multiple
hole sizes allow the use of Mechanical fittings for branching unpressurized pipe lines.
The JK114 has a 5/8" (16mm) capacity drill chuck to accommodate all sizes of hole saws and
hole saw arbors. An integral motor and gear reduction optimizes performance of large
diameter hole saws. The two feed handles allows the operator to use the Hole Cutting Tool
from either the left or right side.
Specifications
Cutting Capacity
Up to 4" (114 mm)
Pipe MountingCapacity
11/4" - 8" (30mm-220 mm)
Drill Chuck Capacity
3-16mm
Drill Chuck Speed
110 RPM (no load)
Motor Horsepower
650W
Dimensions
Height
513mm
Length
260mm
Width
248mm
Pre-Operation Inspection
Before each use, inspect your Hole Cutting Tool and correct any problems to reduce the risk
of serious injury from electric shock and other causes and prevent tool damage.
1. Make sure that the Hole Cutting Tool is unplugged and the ON/OFF switch is in the OFF
position.
2. Clean any oil, grease or dirt from the tool, including the handles and controls. This aids
inspection and helps prevent the tool or control from slipping from your grip.
3. Inspect the Hole Cutting Tool for the following items:
• Inspect the power cord, Ground Fault Circuit Interrupter (GFCI) and plug for damage or
modification.
• Proper assembly and completeness.
