Operating instructions Multi-cell compressor RKL 160
Malfunctions
25
8 Malfunctions
This chapter describes possible causes of malfunctions and
troubleshooting tasks.
Reduce the maintenance intervals if similar malfunctions occur
repeatedly due to above-average intensive use so intervals
correspond to the actual load.
Contact the manufacturer in case of malfunctions that cannot be
repaired with the aid of the following information (
p. 2)!
8.1 Safety
See chapter 2.6 "Occupational safety and special risks".
Personnel
The trouble shooting work described at this point can be carried
out by the operator, unless otherwise indicated.
Some work may only be carried out by specially trained
specialised staff or exclusively by the manufacturer himself.
This is specifically pointed out in the description of the individual
malfunctions.
Only electrical specialists may carry out work on the electrical
system.
Components and parts may only be replaced by specialised
staff.
Personal protective equipment
See chapter 2.5.
Conduct in the case of
malfunctions
The following basically applies:
1.
Immediately switch off the RKL 160 in case of malfunctions
representing an immediate danger for individuals or material
assets.
2.
Switch of all power supplies and secure against restarting.
3.
Inform person in charge at the place of installation.
4.
Depending on the type of malfunction, have the cause
determined and eliminated by responsible and authorised
specialised personnel.
8.2 Recommissioning after corrective action
After corrective action or trouble shooting:
1.
Reset emergency stops.
2.
Acknowledge error message or malfunction at the control
system.
3.
Ensure that nobody is staying in the hazard area.
4.
Start in accordance with the instructions in chapter „start-up“.
Summary of Contents for RKL 160
Page 29: ...Operating instructions Multi cell compressor RKL 160 Index 29...
Page 30: ......
Page 31: ......
Page 32: ......
