10
Power
Power
Power
Power supply
supply
supply
supply mains
mains
mains
mains and
and
and
and DMX
DMX
DMX
DMX 512
512
512
512 connecting
connecting
connecting
connecting
1
、
Power supply mains:
Use the provided plug to connect the main power to the projector. Paying attention to the voltage and
frequency marked on the panel of the projector. It is recommended that each projector be supplied
separately so that they may be individually switched on and off.
2
、
DMX 512 signal cable connecting:
Use 3-pin or 5-pin XLR with dual core shield cable to connect DMX-OUT and DMX-IN, the diameter of
each core must be 0.5mm.
In case of problems, please use high quality shield cable of balance microphone cable, and insert a
terminal into socket for the end of projector(Weld a 1/4W120 ohm resistor for 2
nd
& 3
rd
Pin of 3-pin XLR
connectors)
3
、
Power on for the projector:
After finishing all the operations of above and make sure the lamp is no problem, power on and checking
it's good or not. Lighting on the lamp after power on; projector will reset after few seconds. Meanwhile, if
the projector working normally, the LED shining, DMX 512 signal cables are all working well.
Attention: All the cables should not be twined, otherwise, the projector won't working or working with
problems
DMX512 signal cable connecting.
Please using high quality shield cables.