12
seconds one by one.
�
When magnetic ballast is used, make sure it is five minutes after the bulb is cooled when relight the
lamps. (Electronic ballast can relight by heat)
�
When pull out the cable of power supply, do grip the insulated housing of the plug, do not draw the
cable directly.
Alarm
Alarm
Alarm
Alarm
：
：
：
：
�
Replace the housing,lens and ultraviolet radiation when visible damage takes place, such as cracks.
�
Replace the lamp when damage happens to it or its maximum life is used up.
�
Shut off the power supply when replace lamp, safety box, and any other accessories and when it
does not work.
�
Keep the ground switch connected to ground.
�
Power supply must meet the local standard on architecture and electric signal with overload
protection and connect to earth.
�
Do not make light beam shine on skin, do not look at the light source directly.
�
Prevent short circuit happening to temperature control switch and safety box. When replace
defective fuse, choose approved new fuse of the same type.
�
Keep the distance more than 1 M from equipment to flammable material (such as cloth, wood,
paper).
�
Keep the distance 0.1 M from fan to vent.
�
When housing of equipment feels very hot, cool it for 5 minutes before operation.
�
Advise you to choose accessories produced by us when install and replace.
�
Whenever install or move equipment, set an alarm to prevent others entering job site.
�
Do not put your hand between side arm and light structure when light working. (shown in picture 1
by arrow)
�
Keep the optical system clean. Make the maintenance according to this manual when use in messy
and dusty environment
�
Luminous flux will decrease once the mirror gets covered by fatness or dust.
Solutions
Solutions
Solutions
Solutions to
to
to
to problems
problems
problems
problems
Phenomenon
Phenomenon
Phenomenon
Phenomenon o
o
o
offff power
power
power
power supply
supply
supply
supply
◆
Lamp does not light, motor does not work itself.
When reset, indicator light of On/Off does not light.
◆
Lamp lights, reset, but one of the protocols out of control.
�
Lamp not in stable control for lighting.
�
Light spot not bright enough.
�
Lamp lights, then black out, and lights again in a while.
Causes
Causes
Causes
Causes
：
：
：
：
�
Power supply not in normal state, not well connected, the fuse breaks up.
�
Control cable not connected, or connected not to the right address code, please check the address
code.
�
Voltage is too low, lamp close to using up
◆
Lamp close to using up, optical mirror not clean.
◆
Overheating protection, please check if cooling system is blocked or not.
