EAGLE 3000 Moving Head User Manual
3
SECURE
SECURE
SECURE
SECURE ALARM
ALARM
ALARM
ALARM
When unpacking and before disposing of the carton check there is no transportation damage before using
the luminaire.
Should there be any damage caused by transportation, consult your dealer and do not use the apparatus.
The luminaire is for indoor use only, IP20. Use only in dry locations. Keep this device away from rain and
moisture,excessive heat, humidity and dust. Do not allow contact with water or any other liquids.
The luminaire is not designed or intended to be mounted directly on to inflammable surfaces.
The luminaire is only intended for installation, operation and maintenance by qualified personnel.
The luminaire must be installed in a location with adequate ventilation, at least 50cm from adjacent wall
surfaces. Be sure that no ventilation slots are blocked.
Do not project the beam onto inflammable surfaces, minimum distance is 5m.
Avoid direct exposure to the light from the lamp. The light is harmful to the eye.
Do not attempt to dismantle and/or modify the luminaire in any way.
Electrical connection must only be carried out by qualified personnel.
Before installation, ensure that the voltage and frequency of power supply match the power requirements of
the luminaire.
It is essential that each luminaire is correctly earthed and that electrical installation conforms to all relevant
standards.
Do not connect this device to any other types of dimmer apparatus.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the power-cord come
into contact with other cables. Only handle the power-cord by the plug. Never pull out the plug by tugging the
power-cord.
Keep the lamp clean. Do not touch the lamp glass with bare hand.
The luminaire should always be installed with a secondary safety fixing. A safety cord is supplied for this; it
should be attached as shown in “installing the luminaire” section.
The lamp used in this luminaire is a OSRAM HTI 1200W W/D7/60 discharge lamp. After switching off don’t
attempt to restart the luminaire until lamp has cooled, this will require approx 15 minutes. Switching the lamp
on and off at short intervals will reduce the life of both the lamp and the luminaire. But occasional breaks will
prolong the life of the lamp and luminaire.
Never run the luminaire without a lamp.
The lamp shall be changed if it has become damaged or thermally deformed.
Shields and lens shall be changed if they have become visibly damaged to such an extent than their
effectiveness is impaired, for example by cracks or deep scratches.
There is no user serviceable parts inside the luminaire, do not open the housing and never operate the
luminaire with the covers removed.
Always
Always
Always
Always disconnect
disconnect
disconnect
disconnect from
from
from
from the
the
the
the mains,
mains,
mains,
mains, when
when
when
when the
the
the
the device
device
device
device is
is
is
is not
not
not
not in
in
in
in use
use
use
use or
or
or
or before
before
before
before cleaning
cleaning
cleaning
cleaning it
it
it
it or
or
or
or
before
before
before
before attempting
attempting
attempting
attempting any
any
any
any maintenance
maintenance
maintenance
maintenance work
work
work
work !!!!
If you have any questions, don’t hesitate to consult your dealer or manufacturer.
