TOPSIDE CONTROL INSTRUCTIONS
INITIAL START-UP
When your spa is first activated, it will go into Priming mode, indicated by
“Pr”. The priming mode will last for less than 5 minutes. Then, the spa will
begin to heat and maintain the water temperature in the Standard mode
indicated by “
St
”.
TEMPERATURE (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100°F/37°C. The last temperature is con-
stantly displayed on the LCD.
Note: The last spa temperature displayed is current only when the pump has
been running for at least 2 minutes.
Press the “Temp” button to display the temperature previously set. The set
temperature flashes on the display. Pressing the “Temp” button a second
time, while it is still flashing, will cause the set temperature to increase or
decrease depending on what direction was last chosen. Each press to follow
will change the set temperature in the same direction. If the opposite direc-
tion is desired, release the pad and let the display revert to the actual water
temperature. Press the button to display the set temperature, and press again
to make the temperature change in the desired direction. After
three sec-
onds
, the LCD will stop flashing and display the current spa temperature.
10
Heat On
Indicator Light
Turns Light
On/Off
Controls Low
Speed/High Speed
Pump
Displays Temperature and
Diagnostic Messages
Sets Water
Temperature