38/38
S
ept
.
2014
V3.1
CybTouch 12 PS User Manual
M
SG
n
r
.
M
eSSaGe
d
eScripTion
E69
The machine is not indexed !
No limit
Before the machine is indexed, the NC doesn’t know where the
axes are. In manual page, movements are authorized but the
electronic stroke limits are not activated. Operator is responsible
for stopping axis movement before mechanical limit is reached.
E70
Progr. angle is smaller than the
die angle
The programmed angle is smaller than the die angle. Change die.
E71
Progr. angle is smaller than the
punch angle
The programmed angle is smaller than the punch angle. Change
punch.
E72
Depth safety
The calculated angle causes the punch, material, and die to
collide and approach coining mode. Operator must confirm to
proceed.
E73
Collision backgauge-tool
This message appears to warn that, with the parameters cannot
be entered as such, for they would cause a collision between the
back gauge and the tools. Check your parameters’ values.
E74
Beam error No [ ][ ][ ]
E75
Beam: static gains not found
E76
Error in the parameter beam
(you must correct it before
continuing)
E77
Error in the sequence
parameter (you must correct it
before continuing)
E78
RS232: parity error
E79
RS232: overrun
E80
RS232: framing
E81
RS232: noise
E82
PCSS event No xx
E83
PCSS error time out
E84
PCSS error checksum
E85
PCSS error buffer rec to small
E86
File access error
There was an error when trying to access a file while
programming an option. Make sure that the code was entered
properly. If it is not working try and restart the NC. If the problem
persists, contact Cybelec.
E87
Unknown error
An unknown error occurred while trying to program an option.
Contact Cybelec.
E88
RS232: port already open
E89
Solution not found
This message indicates that the bending sequence automatic
search did not find any solution. Try to create the bending
sequence manually. If not possible, it means that this part is not
feasible on this machine.