7/38
S
ept
.
2014
V3.1
CybTouch 12 PS User Manual
BDC correction
This parameter allows the operator to apply a permanent correction to the Bottom Dead
Center position.
Materials
Touching
Materials
opens the Materials page, where the default characteristics for each
material can be changed, or a new material can be configured.
The Materials page displays:
•
Material
: Selected material (here
Steel
).
•
Default thickness
for the material.
•
Default sigma
: Default sigma for the material (here
45
).
•
Displayed
: If the material will be available to be selected for use (here
yes
).
•
Thickness min/max
: determines the maximum and minimum accepted thickness for
the selected material.
Three predefined default materials are available (steel, stainless steel, aluminum), but
others can be added.
To add a material:
1. Touch
Material
and select a non-configured material (Mater X) from the list.
2. Enter the new material’s characteristics.
3. Touch the name (Mater X) to display the keyboard and enter the name of the new
material.
This page may not be available, depending on the machine parameters’
configuration. To be allowed to access the Materials page, a level 2 password is
required.
Please note that this correction is always applied and is NOT shown in the
correction page. If you experience big differences from what you expect to get,
maybe check the value of this parameter.
