27/38
S
ept
.
2014
V3.1
Angle value
More parameters for step
Segment length
Program number
Program number
Tools selection
Material and thickness
Step value
Step number
Browsing through
the steps
CybTouch 12 PS User Manual
l-a
lpha
M
ode
→
In this mode, the operator can define each step (length or angle) of a profile on a table.
S
etting
i
nStructionS
:
1. Touch the program number, select
New program
in the list and press
this button
to access the L-alpha
mode.
2. First select the material, its thickness
and the tools to be used for the part by
touching their respective icons.
3. Touch the first value in the table (here
200.00
). The window to the right is
displayed.
4. Enter the value for the first segment’s
length and touch the
button to add
another step.
Click on OK when prompted to create
new step.
5. Proceed in the same manner for all
steps and angles of the profile.
6. If a bend needs special parameters
(large radius, special tool), press in
the more field of the corresponding
sequence.
A special punch or /and die means
there must be an additional working
station.
This page is only available if user preference
yes
.
→