User Manual
–
CybTouch series
CybTouch series
–
User Manual
J
AN
.
2020
V5.0
40/98
Once the shape of the part has been defined, the bending sequence for the part can be
determined.
S
ETTING INSTRUCTIONS
:
1.
If available, touch the bend sequence calculation button
. Once the sequence
is calculated, the Bend 2D screen is displayed.
2.
If the option is not installed, simply touch the bend in the order that you want
them performed. A small number is displayed on the bend, indicating its position in
the sequence.
Pressing the back
button will erase the last bend in the sequence. If you wish to delete
all bends, simply touch the
button.
3.
Immediately after determining the last bend to be selected, the Bend 2D screen
here below is displayed.
4.
In the Bend 2D page, the operator must determine the back gauge and part
position for each bend, and if necessary Extra Bending Parameters.
5.
Press
and select
Bend num page
6.
Start the hydraulic pump motor (by pressing this button
if available. It turns
red when the motor is running).
7.
Press the
button to position the machine according to the data that were just
entered.
8.
When the machine is ready to bend, a
button is displayed.
9.
If you want to repeat the same step in order to apply all the necessary corrections
to it, switch to the
10.
Press the foot switch to execute the bend.
Numerical Mode
Browsing through
the bends
Next gauging point
Switch between stop
or support gauging
Touch the drawing to
toggle between Bend
Order page and this one
Extra Bending Parameter