®
30/38
CybTouch 8 P User Manual
S
ep
.
2019
V2.1
M
akinG
a
bend
on
The
e
aSy
b
end
p
aGe
e
aSy
b
end
P
aGe
The EasyBend page is used for individual bends, for example when an external worker
needs to interrupt production just to make a single bend (usually with the same tools).
The program currently being used for production is only temporarily interrupted
(no need to save it) when switching to the EasyBend page, and then resumed
again when returning to the program page (
→
Current program).
(
)
→
EasyBend
See
Basic Page Description, page 14
for more information on the different
controls on the EasyBend page.
S
etting
i
nStructionS
:
1. Touch the material’s thickness (here
1.00
is displayed. Enter the
and the
2. If necessary, touch one of the tool’s icon (
or
) to select a punch or die. (To
learn how to configure tools, please refer to section
).
3. Enter the angle
for the bend you wish to create (here
90°
).
4. Enter the flange’s length
(here
275.00 mm
).
5. Press this button
and enter the
eventually required extra data for the bend.
6. Start the hydraulic pump motor (by pressing this button
if available. It turns red
when the motor is running).
7. Press the
button to position the machine according to the data that were just
entered.
8. When the machine is ready to bend, a
button is displayed.
9. Press the foot switch to execute the bend.
