SAFETY AND MAINTENANCE INSTRUCTIONS
PAGE I
S
AFETY AND
M
AINTENANCE
I
NSTRUCTIONS
!
The operator must be trained for working with the
machine on which the numerical control is installed.
!
Improper use of the numerical control can cause
heavy damage on equipment and/or injuries to
people.
!
Modification of machine parameters can cause
important material damage or lead to irregular
product quality.
!
The rear panel may only be removed by a qualified
technician (danger of electrocution).
!
Do not expose the numerical control to excessive
humidity so as to avoid any risk of electrocution and
any deterioration of the equipment.
!
Make sure the numerical control is disconnected
from the mains power before carrying out any
cleaning. Do not use liquids based on alcohol or
ammoniac.
!
In case of malfunction of the numerical control, call a
technician.
!
Do not expose the numerical control to direct sun
rays or any other heat source.
!
Do not place the numerical control in the
neighbourhood of magnetic equipment such as
transformers, motors or devices which generate
interference (welding machines, etc.)
!
Replace fan filters at regular intervals so as to avoid
overheating.
Summary of Contents for DNC 60 GS
