SAFETY AND INTERACTIVE MESSAGES
PAGE 59
INDEXED
Machine indexing.
INSERTED
Indicates that the insertion has been made
correctly.
LAST
Displayed in
mode when the sequence
shown is the last of the product.
LIMIT !
This message appears when the calculation of a
shears function (blade gap, rake angle, BDC or
TDC) exceeds the limits fixed by the machine
parameters.
The DNC limits the calculated value to the limit
defined in the machine parameters and positions
the cursor on the function in default.
MachPar
Indicates that an N2X machine parameter is not
valid. You must refer to the specific N2X
manual.
MODIFY
Displayed when the operator programs the
DNC.
N2XPause
Indicates that the corresponding axis has been
temporarily
PAUSED
by means of the defined
input.
NEXT
Is displayed during successive display (
key) of the sequences which exist in the buffer
(except for the last sequence which indicates
END).
NO SPACE
Indicates that the product list memory has no
more space available.
NO-ACTIV
Indicates an attempt to change to
or
mode on a sequence where the CY is
programmed at 0.
PausCycl
At rising edge the machine cycle is stopped
(interrupted). At falling edge the cycle
continues.
PC <–> DNC
Indicates a transfer from a PC towards a DNC.
PositTol
One of the axes is not in the tolerance.
PREVIOUS
Same as NEXT but with the
key.
RESTORE !
Displayed when the next product is loaded in
the DNC from the exterior, for instance a PC.
Summary of Contents for DNC 60 GS
