27/40
ModEva Pac User Manual
A
pril
2016
V2.3
b
endinG
, T
eSTS
and
c
orrecTionS
This chapter explains how to proceed in order to execute a product. This way of doing is
destined only to demonstrate how to use the numerical control.
The testing and adjusting operations can be carried out in the order decided by the
operator.
•
B
ending
S
Peed
, defines the downward bending speed and the upward moving speed
from BDC to Pinch Point point.
•
L
oW
S
Peed
d
iStance
, defines the portion (expressed in %) of the upward movement
between the TDC and the Pinch Point which will be carried out at low speed; the
continuation of the upward movement is made at high speed.
Complementary explications are found in the
2D Reference Manual
.
S
etting
i
nStructionS
:
1. Go into semi-automatic mode
.
2. If necessary, move to the first sequence by means of the
and
keys.
3. Press the start key
in order to position the axes on the first sequence.
4. Carry out the bend with a trial product.
5. Measure the flap and the obtained angle.
6. Touch the
button and select
c
orrectionS
in the list.
In the screen above, the correction of
-2.00
MM
corresponds to the material
thickness when programming section 2 in
.
7. If necessary, correct the flap (in this example, a correction of X =
- 0.10
is assumed)
for the current bend.
