- 12 -
3
、
This field shows the list of connections to the KVM, and the fields are described below:
PWR: It shows the status of power supply and indicates a normal power supply for the
equipment (PC or KVM) connected to the CPU port.
C# : It shows the channel number; the IC-1704 will display 01~04; the IC-1708 will display
01~08 and the IC-1716 will display 01~08; 09~16 (Since the screen cannot display all at
a time, therefore you can use PgUp/PgDn to switch the pages).
KVM: It shows the KVM model. If there is a number in this field, it shows that a set of
KVM connects to this port. The number 04 indicates Port 4 and 08 indicates Port 8
and 16 indicates Port 16 and so on.
Note: If the connected KVM is not on, there will have no number in this field.
NAME: It shows the name of the equipment, and users can name the Slave KVM or PC on
their own. There are a total of 12 characters selected from the group of “A~Z”,
“a~z”, “0~9” , “
＋
”, “
－
” , “
＊
”, “ ” , “
＝
”, “
〔
”, “
〕
”, “
，
”, “
．
”, “
：
”.
Note: Please use the CapsLock to toggle the upper and lower cases.
SVS: It shows the Smart View Setting; use
⊕
to open and
Θ
to close. The SVS is blank
and not clickable if the KVM is connected in parallel.
If this option is set to open, then you can make the switch by operating the Hot Key
Switch or Mouse Clicking or selecting the option by Auto Scan. You also can use
mouse to click this field.
Selection BAR: It shows the selection bar (Green); you can use the ?? keys on the board to
move the selection bar, and the situated position indicates the selected target
for giving instructions. For example, if the selection bar points at C#05 and
you press Enter, then the system will switch to that particular PC or press the
“Space BAR” to start editing the name. Press F4 to enable/disable the SVS
option.
4
、
Instruction Hint Field:
F
G
??: Move; Use the ?? keys on the keyboard or the mouse to move the selection bar.
SPACE: Edit; The “Space BAR” on the keyboard is used to start editing the name of the PC
or KVM.
ESC: Exit; Use the “Esc” key on the keyboard to exit the current option or exit OSD.
F4:
Auto Scan; Use the F4 key to run Auto Scan, and you can set the residing time, channel
display time and mode of the Auto Scan from System Setting.
F9: System Setting; Use the F9 key to enter into the System Setting Menu.
F5: Clear Name List; Use the F5 key to clear the values of all Name fields. If you clear the
name list under the Master screen, then you will also clear the name lists under all slaves.
If you clear the name list under a certain slave, then you only clear the name list under
that particular Slave KVM.
F1: Smart View; It switches the Smart View Setting.
Summary of Contents for IC-1704
Page 1: ... 1 LCD KVM SWITCH IC 1704 IC 1708 IC 1716 USER MANUAL ...
Page 16: ... 16 ...
