- 14 -
position. You can use the Up, Down, Left or Right keys on the keyboard or a mouse to move
the OSD position.
F8: Restore Default Setting; Restore the factory default settings. Please note that all name lists
will be cleared and the system settings are set to the default settings as shown in the table above.
Esc: Exit; Exit the system setting and close the OSD. If you have made changes in this option,
the system will ask whether or not you want to save the setting before the selected option is
effective.
Auto Scan Mode:
•
You can start the OSD first and press “F4” to enter the Auto Scan Mode.
If you want to scan the PC, you must use the Smart View Setting to select the Auto Scan Time
in the System Setting for the residing time, which includes 5 sec, 10 sec, 20 sec, 30 sec and 60
sec. You can adjust the Channel Display Mode and Channel Display Time from the Channel
Display mode. By then, all keys on the panel, keyboard and mouse are not operable. You
can only use the ESC key to exit the Auto Scan Mode.
Security Mode:
•
Switch the Security Level from “None” to “Low” in the System Setting, and
enter your Password (“A~Z”,“0~9”, a maximum of 12 characters), and the security will be
effective after you confirm the Password. The use of the Console Lock Time is to set the
time to enter a security mode after the keyboard and mouse has idled for a predetermined time.
Once you enter into the security mode, you need to enter the correct password before you can
move the mouse or enter any key from the keyboard. You need a correct password to operate
the whole system normally.
Important Note:
What should I do if I forgot my Password?
After you enter a wrong password for 5 consecutive times, a time delay bar will appear, and a set of
“Magic Numbers” will show up at the bottom. Record the magic numbers and contact with your
distributor.
EDID
•
& DDC:
A vast majority of computer monitors supports the Extended Display
Identification Data (EDID) and allows data access by Display Data Channel (DDC). The KVM
also supports these two specifications, but the KVM only reads the EDID of the Monitor when
the KVM is on. If it is necessary to change monitors during an operation, please use the
Console Reconfirmed function to read the EDID again.
F/W U
•
pdate:
This product provides a firmware update function. You can contact your
distributor for downloading application programs and updated files. Use the F/W Update Cable
for the update. Please turn off all PCs before carrying out the update, and do not disconnect the
power during the update process.
Procedure:
1. Download and install the application program KVMISP.msi. (Note: This program has to be
run only in Win98SE, ME, XP or 2000).
2. Connect the F/W Update Cable, and the PC end is RS-232 port (COM-X) while the KVM
end is the updata port.
3. Power on the KVM and run KVM-ISP.exe. Select the COM port.
4. Select the Download function and specify to update the KVM-XXXX.KVM file.
5. After the update completes (which takes about 1.5 min), power off the KVM. Unplug the
F/W Update Cable. Power on the KVM again.
6. You can use the system setting “F1”- Information in the OSD to examine whether or not the
Summary of Contents for IC-1704
Page 1: ... 1 LCD KVM SWITCH IC 1704 IC 1708 IC 1716 USER MANUAL ...
Page 16: ... 16 ...
