5.3.3 Wiring External Battery Input
1
Loose the screw of battery connector by screwdriver and pull out the connector.
2
Tight connector screws after you insert battery-wires to lock them into place. An
AWG14
wire type is
recommended. Place the battery connector back to the unit and tight it into place.
Fig. 5-4 Location of extended battery connector
To reduce the risk of electric shock, avoid touching the live components
and treat the terminals carefully.
NEVER
connect or disconnect the connectors under load.
Risk of damage to the unit.
If the voltage of the battery exceeds the maximum input voltage of the
unit, it can be destroyed by the overvoltage. This will void all warranty
claims.
If the polarity of battery is reversed connect, it can damage the unit fuse
and unit can’t operate anymore. Before connecting, make sure the polarity
is correct.
Battery type must be valve-regulated lead-acid battery
Improper operation during the wiring process can cause fatal injury to
operator or unrecoverable damage to the unit.
WARNING
!
NOTICE
!
NOTICE
!
User Manual
11 Hybrid CPSHB300ETR-IN
Summary of Contents for CPSHB300ETR-IN
