10
Mounting Using Square Holes
1. Install the included black M6 cage nuts from the back of the rack angles as shown
below, and press the sides of the cage nuts to make sure they have been inserted
properly.
5
6
5
6
4
4
CyberPower’s wall mount enclosures have dual-hole rails, square holes and #12-24
threaded round holes. To change the type of mounting holes that are facing forward
please see the
Adjusting Rack Angles
section. Use the black cage nuts and black
screws for square holes, and use the silver #12-24 screws for the round holes.
NOTE:
Please review your equipment instructions carefully before installing in the enclosure.
Equipment Installation
●
Verify that the enclosure is securely mounted to the wall prior to installing any
equipment.
●
It is strongly recommended to first install equipment in the bottom of the enclosure.
Heavier equipment should be installed in the bottom of the enclosure.
●
If using sliding rails with installed equipment, use caution when pulling the
equipment out of the enclosure as it can cause loading to shift and increase the
hazard of tipping or failing. If multiple pieces of equipment use sliding rails only slide
one piece of equipment out at once.
CAUTION
To ensure proper and secure installation, cage nuts need to be installed horizontally
as shown below. Installing cage nuts in the incorrect orientation can cause injury or
equipment damage.
CAUTION
