31
Appendix B-Power Device Network Utility
Figure 7. Windows Security Alert
Launch Program
To launch the Power Device Network Utility and get started, select
Programs from the Start menu in Windows and locate the new
folder and icons for Power Device Network Utility. Select Power
Device Network Utility from the program folder (Shown in Figure 5).
Getting Started
The Power Device Network Utility scans the network for devices with
MAC addresses that match CyberPower network hardware. Once
found, the device(s) can then be figured with a specific IP address,
subnet mask, and gateway address. This allows the device(s) to function
properly on the network and interface with CyberPower Management
Console.
Step 1. Select the appropriate PDU device from the Equipment List
(Shown in Figure 6).
Figure 6. Equipment List
Figure 5. Power Device Network Utility
Note:
If the PDU does not appear on the list, click the
Refresh
button to
rescan the network. If it still does not appear, ensure that the PDU
is turned on and was installed correctly.
Pressing
Stop
will cancel the scan/refresh process.
Note:
If your computer has a software firewall installed, you may
see a Windows Security Alert message (Shown in Figure 7).
In Windows XP SP2, the default firewall alert message is shown
as Figure 7. You need to allow the Power Device Network Utility
access through the firewall.
