Operations Guide
931281I
CyberData Corporation
2.2.20 Confirm the IP Address and Test the Audio
2.2.20.1 RTFM Switch
When the InformaCast Enabled Loudspeaker Amplifier (AC-Powered) is operational and linked to
the network, use the Reset Test Function Management
(RTFM)
switch (
) (located behind
the hole on the device) to announce and confirm the device’s IP Address and test the audio to verify
that it is working.
Figure 2-26. RTFM Switch
Announcing the IP
Address
To announce a device’s current IP address:
•
Use a bent paperclip or a similar object to press and hold the RTFM switch for a couple of
seconds and then release it.
GENERAL ALERT
Caution
Equipment Caution:
Pressing and holding the RTFM switch for more than five
seconds will restore the device to the factory default settings. See the “
” section.
Restoring the
Factory Default
Settings
To restore the factory default settings, complete the following steps:
1. Use a bent paperclip or a similar object to press and hold the RTFM switch until you hear the
device announce the words, “restoring defaults” and “rebooting”.
2. Release the RTFM switch. The device will be restored to the factory default settings.
RTFM switch
(located behind the hole
on the device)
Summary of Contents for InformaCast Enabled 011406
Page 80: ...Operations Guide 931281I CyberData Corporation Figure 2 41 SSL Configuration Page ...
Page 81: ...Operations Guide 931281I CyberData Corporation Figure 2 42 SSL Configuration Page ...
Page 90: ...Operations Guide 931281I CyberData Corporation Figure 2 47 Audiofiles Page ...
Page 91: ...Operations Guide 931281I CyberData Corporation Figure 2 48 Audiofiles Page ...
